Huawei OceanStor VIS6300 Quick Installation Manual page 33

c
Connect the Other End of the Network Cable to the Port of the
Ethernet Switch or the Network port of the Maintenance Terminal
Scenario 1: Connecting the Other End of the Network Cable to the Port of the
Ethernet Switch When the Management Network Adopts the Switch Networking
Scenario 2: Connecting the Other End of the Network Cable to the Network Port of
the Ethernet Switch When the Management Network Adopts the Direct Connection
Networking
If the maintenance terminal is connected to the configuration network port of the VIS6000, it cannot
provide a network port to connect the management network port. In this case, perform this operation after
setting the IP addresses of the management network ports of controller A and controller B and
disconnecting the configuration network port of the VIS6000 from the maintenance terminal.
3 Connecting the Maintenance Terminal to the
Switch
This process is optional. If the management network adopts the directly connection networking, skip this
section.
32