Huawei OceanStor VIS6300 Quick Installation Manual page 17

Scenario 2: Networking for Connection of the Production
Center and the Disaster Recovery Center (Only the Ethernet
Switch Is Used in the Networking of the Production Center and
the Disaster Recovery Center)
Storage arrays
The connection of port modules on the left and right of the rear of the VIS6000 is symmetrical. The
following operation takes port modules on the left of the rear of the VIS6000 as an example. For the
connection of port modules on the right, see the following installation procedure to perform similar
operations.
The signal cables are wired on the right of the rear of the cabinet (you can lead signal cables connected
to the left port modules to the right of the cabinet by using the cable tray). When cabinets are connected,
wire the connecting cables inside the cabinet support bridges.
For the FC service ports to which FC cables are not connected, use protective caps.
2 Connecting the VIS6000 to the Switch
a
Connect One End of the Cable to the Service Port of the VIS6000
Scenario 1: Connecting One End of the Optical Fiber to the FC Service Port of the
VIS6000
Linux
Windows AIX
Ethernet
switch
Ethernet switch
WAN
VIS6000
Maintenance terminal
Ethernet switch
VIS6000
Storage arrays
Maintenance terminal
16
Ethernet switch
Network cable