Operation - TE Connectivity 1213890-1 Customer's Manual

10. When the dies are aligned, fully tighten the die retaining screws.
11. Install the locator assembly onto the long retaining screw and secure it with the appropriate hex nut.
3.2. Removal of Shouldered and Pinned Dies
To avoid personal injury, remove the battery before removing dies.
DANGER
To remove dies from the crimp head, remove the die retaining screws, die retaining pins, ram plate, and slide
the dies out of the crimp head.

4. OPERATION

4.1. Battery Installation and Removal (Refer to Figure 1)
The Batteries Directive 2006/66/EC introduces new requirements from September 2008 on removability of batteries
NOTE
from waste equipment in EU Member States. To comply with this Directive, this device is designed to allow the
i
rechargeable battery pack to be easily removed by the end- - user when it needs to be replaced.
To install the battery, slide the battery into the bottom of the crimp tool until it can go no further. There will be an
audible "click" of the battery lock to indicate that the battery has been properly installed.
To remove the battery, disengage the battery lock by applying pressure on the lock toward the bottom of the
tool and slide the battery away from the tool.
Always dispose of the old battery pack in an environmentally- - responsible way, in accordance with local waste
DANGER
regulations. Where possible, please recycle the battery cartridge. Contact your local authority for details of battery
recycling locations in your area.
4.2. Crimping
The following procedure provides only general information concerning crimping. Refer to the instructions
packaged with the dies for detailed information, including wire stripping dimensions and instructions for
positioning terminals and splices in the dies.
To operate the SDE Battery Powered Crimp Tool 1213890--[ ]:
To avoid personal injury, keep fingers clear of the crimping area.
DANGER
1. Insert the terminal into the dies.
2. Depress the trigger to advance the moving jaw in order to hold the terminal in place. Do NOT deform
the terminal body.
3. Place a pre--stripped wire in the barrel of the terminal.
4. Depress and hold the trigger to complete the crimp. The crimp tool returns automatically to the first
position of its cycle when the crimp is complete.
If it is necessary to retract the ram before a crimping cycle is completed, push the release switch. Pushing the release
NOTE
switch will result in the complete retraction of the ram. Only kits 1213890- - 1, - - 2, and - - 5 have a release switch.
i
This tool is not designed for continuous operation. After 100 cycles, allow the crimp tool to cool for 15 minutes.
CAUTION
!
8 of 9
409- 10065
Rev F