Indoor Unit Registration - Fujitsu UTB-YDB Installation Instruction

INDOOR UNIT REGISTRATION

G A maximum of 8 remote controller groups can be registered for a Group remote controller.
G Remote controller groups in 2 different refrigerant systems that are connected to a single convertor can be registered.
G The remote controller groups registered can be monitored and controlled.
G When registering indoor units to each of the buttons, consult the customer.
Indoor unit registration screen
Initial Screen
See EXPLANATION OF TERMS on page 5 for
explanations of each address.
Indoor Unit Registration Methods
G Manual registration
G Automatic registration (J-series only)
Manual Registration
To register indoor units manually
G Registration position selection
1
Press the Select button to select the position for registering the indoor unit
G Refrigerant circuit address selection (Not used for J-series)
2
DAY
Press the DAY button to select the refrigerant circuit address for the indoor unit being registered.
• Hold down a Set Time button to scroll through the addresses quickly.
3 When a remote controller group made up of a single indoor unit is registered, select the indoor unit address.
G Indoor unit address selection
Decrement Increment
Press the Set Time buttons to select the indoor unit address for the indoor unit being registered.
• Hold down a Set Time button to scroll through the addresses quickly.
2
4
Remote controller address
(Not shown with J-series)
For J-series
Refrigerant circuit address
(Not shown with J-series)
1
Registration position
3
Indoor unit address
En-11