Installation - Elation SIX PAR Z19 IP User Manual

I N S T A L L A T I O N
ENSURE ALL CONNECTIONS AND END CAPS ARE PROPERLY SEALED WITH A
DIELECTRIC GREASE (AVAILABLE AT MOST ELECTRICAL SUPPLIERS) TO PREVENT
WATER CORROSION AND/OR ELECTRICAL SHORT CIRCUIT.
DO NOT INSTALL THE FIXTURE IF YOU ARE NOT QUALIFIED TO DO SO!
Fixture MUST be installed following all local, national, and country commercial
electrical and construction codes and regulations.
Before rigging/mounting the fixture to any metal truss/structure or placing the fixture
on any surface, a professional equipment installer MUST be consulted to determine if
the metal truss/structure or surface is properly certified to safely hold the combined
weight of the fixture, clamps, cables, and accessories.
Fixture ambient operating temperature range is
Do not use the fixture under or above this temperature.
Fixture should be installed in areas outside walking paths, seating areas, or away
from areas were unauthorized personnel might reach the fixture by hand.
NEVER stand directly below the fixture when rigging, removing or servicing.
Overhead fixture installation must always be secured with a secondary safety
attachment, such as an appropriately rated safety cable.
Allow approximately 15 minutes for the fixture to cool down before serving.
F L A M M A B L E M A T E R I A L W A R N I N G
Keep fixture at least 5.0 feet (1.5m) away from any
flammable materials, decorations, pyrotechnics, etc.
E L E C T R I C A L C O N N E C T I O N S
A q u a l i f i e d e l e c t r i c i a n s h o u l d b e u s e d f o r a l l
e l e c t r i c a l c o n n e c t i o n s a n d / o r i n s t a l l a t i o n s .
w w w . e l a t i o n l i g h t i n g . c o m
w w w . e l a t i o n l i g h t i n g . c o m
-5° to 113°F. (-15° to 45°C)
11
SIX PAR Z19 IP™ User Manual