Tenda A301 User Manual page 15

Method 2: Extending your WiFi network using WPS
You can use this method if your router/modem has a WPS button, which may be indicated by
or . Otherwise, use
Step 1 Plug the repeater into a power outlet within 2 meters of your router/modem in the same room. Wait
until the PWR LED turns solid blue.
Step 2 Press the WPS button on the router, and then press the WPS button on the repeater within 2
minutes.
Step 3 Wait until the Signal LED on the repeater lights on. The repeater expands your existing WiFi network
successfully.
If the Signal LED on the repeater does not light on, use
using web UI.
Step 4 Plug the repeater into an outlet halfway between the router and the WiFi dead zone. The location
you choose must be within the range of your existing WiFi network.
Wait about 1 minute. Use the following status of the Signal LED to see whether the repeater is at a
Step 5
proper position.
−
Blue: proper position
Red: move the repeater closer to the WiFi router/modem
−
−
Off: move the repeater closer to the WiFi router/modem
Method 1: Extending your WiFi network using web UI.
Method 1: Extending your WiFi network
10
, ,