Table of Contents
Advertisement
6 Update
firmware
To improve the performance of DS6800W,
Philips may offer you new firmware for upgrade
of your DS6800W.
Please register your product at www.philips.
com/welcome for information about the latest
firmware.
Note
•
You can only update the firmware from a PC/Mac.
Download the update file
www.philips.com/support
www.philips.com/support
XXXX
XXXX
XXXX. zip
XXXX. zip
1
On your PC/Mac, go to www.philips.com/
support.
2
Enter the model number to find the latest
firmware upgrade file available.
3
Save the upgrade file to your hard drive.
26
EN
Update from the
configuration page
Warning
•
Always connect your DS6800W to AC power for
firmware upgrade. Never power off your DS6800W
during firmware upgrade.
Note
•
To use an Internet browser other than Apple Safari
on your PC/Mac, remember to go to the Wi-Fi router
configuration page and write down the IP address of
your DS6800W. See the user manual of your Wi-Fi
router for how to find the IP addresses of devices
connected to the Wi-Fi router.
1
Power on DS6800W (see 'Prepare' on
page 11).
»
It takes about 35 seconds for the unit
to boot up. During boot-up, the WI-FI
SETUP indicator on the back of the
main speaker blinks green quickly.
»
After boot-up, you can hear a beep
and the WI-FI SETUP indicator
turns to green steadily. DS6800W is
connected to the last configured Wi-Fi
network automatically.
2
Make sure that DS6800W and your
PC/Mac are connected to the same Wi-Fi
router.
3
Open Apple Safari on your PC/Mac, then
select 'Philips_Fidelio XXX' from the
Bonjour pull-down list.
•
Or open another Internet browser
on your PC/Mac, then type in the IP
address of DS6800W (available on
the Wi-Fi router configuration page)
at the address bar.
»
The DS6800W configuration
web page is displayed.
4
Select the Firmware Update tab, then
follow the on-screen instruction to enter
the next page.
5
Click Choose File to select the
downloaded firmware update file, then
click Open.
6
Click Upload to upload the file, then
compare the current and new file versions.
7
After you make sure that the downloaded
update file is the latest, click Ok to start
firmware update.
»
A progress bar is displayed.
8
At completion of the update process, click
Ok to confirm.
Firmware upload status: 100% completed.
Firmware upload status: 100% completed.
The upload process finished successfully.
The upload process finished successfully.
Wait until the new firmware is started and then press the button.
Wait until the new firmware is started and then press the button.
Note
•
In case the firmware update fails, you can try the above
procedures again.
•
After successful firmware update, if there is any
problem with the Wi-Fi connection, press and hold
both the + and - buttons on DS6800W for more than
5 seconds at the same time to reset the device, and
then try to set up the Wi-Fi network for DS6800W
again (see 'Connect to your home Wi-Fi network for
AirPlay' on page 13).
EN
27
Advertisement
Table of Contents
