Stream from your Wi-Fi enabled PC
or Mac installed with iTunes 10 (or
later)
Note
•
Before you open iTunes, make sure that you have
enabled Bonjour service in your PC. Take Windows
XP for example: to enable the service, you can click
Start->Settings->Control Panel, and double-click
Administrative Tools-> Services->Bonjour Service,
and then click Start followed by OK on the pop-up
menu.
1
Open iTunes 10 (or later).
2
Click the AirPlay icon at the bottom right
corner of the window.
3
Select Philips_Fidelio_AirPlay XXXX (or
user customized name) from the list.
4
Select a media file and start play.
5
Wait until successful audio streaming to
the speaker.
Control play
You can select different play options from either
your AirPlay device or the supplied remote
control.
Note
•
All the operations below are based on the supplied
remote control.
•
To start or pause play, press
•
To skip to the previous or next track, press
/ .
•
To adjust volume, press +/- repeatedly.
•
To mute or restore volume, press .
•
To switch to the AUX IN source (if
connected), press .
•
To switch back to the AirPlay device
source, press .
20
EN
Advanced control
For advanced control, you can use your
AirPlay device to download the Philips
Fidelioapplication from Apple Application Store.
Update firmware
•
Download the update file
1
2
3
Update from the configuration page
You can update the firmware in two different
ways.
Option 1 (recommended): the unit and PC/
Mac connected to the same wireless router
1
2
.
3
Note
You can only update the firmware from a PC/Mac.
On your PC/Mac, go to www.philips.com/
support.
Enter the model number to find the latest
firmware upgrade file available.
Save the upgrade file to your hard drive.
Make sure that the unit and PC/Mac are
connected to the same wireless router.
Power on the unit (see 'Prepare - Connect
- Connect power').
»
It takes about 35 seconds for the
speaker to boot up. During boot-up,
the
indicator on the front of the
main unit blinks in green quickly.
»
After boot-up, the
blink in green slowly.
Open Safari on your PC/Mac, and then
select 'Philips_Fidelio XXX' from the
bonjour pull-down list.
•
Or open the web browser on your
PC or Mac, and then type in the IP
address of DS8800W (available at
indicator starts to
Need help?
Do you have a question about the Fidelio SoundCurve DS8800W and is the answer not in the manual?