For first-time use:
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one CR2032 battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
Before you press any function button on the remote
control, first select the correct source with the remote
control instead of the main unit.
•
If you are not going to use the remote control for a
long time, remove the battery.
•
Point the remote control directly at the IR sensor on
the front of the main speaker for better reception.
12
EN
4 Connect to
your home Wi-
Fi network for
AirPlay
To connect DS6800W to your existing home
Wi-Fi network, you need to apply your home
Wi-Fi setting to DS6800W.
You can do this in two ways (depending on
which type of Wi-Fi router you use):
•
Automatically - if your Wi-Fi router
is WPS (Wi-Fi Protected Setup)-
enabled and supports PBC (Push
Button Connection) (see 'Scenario 1:
Connect to a WPS router' on page
13)
•
Manually - if your Wi-Fi router does
not support WPS (see 'Scenario 2:
Connect to a non-WPS router' on
page 14)
Once connected successfully,
DS6800W will remember your
home Wi-Fi settings. Then you can
enjoy AirPlay whenever DS6800W is
powered on and connected to your
home Wi-Fi network automatically.
Before connection of DS6800W to
you home Wi-Fi network, check the
points below.
1
Make sure that your Wi-Fi router is
powered on and working properly.
2
Make sure that DS6800W has been
powered on and booted up successfully
(see 'Turn DS6800W on' on page 11).
3
Identify the type of your Wi-Fi router (see
the user manual of your Wi-Fi router for
details).
Scenario 1: Connect to a
WPS router
Note
•
Before you press any button on DS6800W, make sure
that DS6800W has been booted up successfully (see
'Turn DS6800W on' on page 11).
1
Press the WPS button on your home Wi-Fi
router.
WPS
WPS
2
Shortly after step 1, press Wi-Fi SETUP on
the back of the main speaker.
»
The Wi-Fi SETUP indicator blinks red,
yellow and green alternately.
»
Within 2 minutes, the WI-FI SETUP
indicator stops blinking and stays green,
and the unit beeps.
»
DS6800W is connected to your home
Wi-Fi network successfully.
EN
13