Philips Fidelio SoundSphere User Manual page 10

3
Select 'Philips_Fidelio XXX' from the
Bonjour pull-down list shown at the
bookmarks bar.
»
The DS6800W configuration web
page is displayed.
Change the internal Wi-Fi settings of
DS6800W
On the DS6800W configuration web page,
you can change the internal Wi-Fi settings of
DS6800W for connection of DS6800W to
your existing home Wi-Fi network.
Note
•
Make sure that the settings at steps 2 to 4 below match
your home Wi-Fi network settings you wrote on paper.
1
Select the Network Configuration tab.
18 EN
Network Configuration Network Configuration
2
Select your network name (SSID) from the
pull-down list of Service Set ID (SSID).
3
Enter your network key if required.
4
If DHCP mode is disabled in your home
Wi-Fi router, tick DHCP under Advance
Setting.
5
Click Apply at the bottom of the page to
apply your new settings.
»
A menu for confirmation of your
change pops up.
6
Click OK on the popup menu to confirm
your change.
»
After a while, the WI-FI SETUP
indicator on the back of DS6800W
stops blinking and stays green, and the
unit beeps.
»
DS6800W is connected to your
existing home Wi-Fi network
successfully.
EN 19