Table of Contents
Advertisement
XT-2 Reader Installation Manual & Data Sheet
Figure 3 XT-2 reader mounted on a pole with XT-2 Mounting Kit
Mounting hole layout details are available in section 5.5.2, "Dimensions".
Note: Do not drill any additional holes in the enclosure, as that would affect the sealing
specification.
Caution!
Never exceed the environmental and electrical limits specified in section 5, "Technical
Data". Exceeding the limits can result in permanent damage to the reader.
3.4
Mounting the External Antenna (Optional)
The optional external antenna has the same physical dimensions and RF performance
as the reader and should be mounted in the same way as the reader (see section 3.3,
"Mounting the Reader").
Different reader models require different external antennas:
Part No.
162100
162200
Connect the external antenna to the reader using an RF cable with RP-TNC
connectors. Cables supplied by TagMaster are tuned to give maximum performance
while still being within the regulatory limits.
The following cables are available:
Part No.
196025
196050
© TagMaster
Model
External XT-2 eu antenna
External XT-2 us antenna
Model
Antenna cable 2.5 m
Antenna cable 5.0 m
Doc no. 10-407 02
9 (26)
Advertisement
Table of Contents
