Mechanical Installation; General; Readers; Mounting - TagMaster S1566 Installation Manual

TagMaster AB
HW Installation Guide
9

MECHANICAL INSTALLATION

This chapter describes the procedure of installing the TagMaster units mechanically.
It is assumed that the location of Readers and Tags are specified, and the communication
distances and movement speeds are considered during the project planning phase. Likewise it is
assumed that the project planning is well documented.
9.1

General

Microwaves penetrate wood, dirt, paint, plastic, and most other non metallic materials.
The TagMaster system employs circular polarisation and can therefore also often be used when
metal surfaces are in the vicinity of the antenna and Tag, especially if the Tag is moving. In such
cases however, adjustment of the Tag/Reader position and distance may be necessary to find the
best position. Always combine this with tests to verify that the installation will work.
9.2

Readers

9.2.1

Mounting

• Position the Reader with the cable entries pointing downwards and so that the device is easily
accessible for service.
• Mount the Reader in an adjustable holder and direct it so that its lobe beam covers the
position of the Tag(s).
• If Tags are to be mounted in car wind screens it is recommended to mount the Reader
approximately 2 meters up and tilted down for best performance. Refer to the typical
installation illustrations in section 5.5.
MECHANICAL INSTALLATION Manual issue 01
15