Table of Contents
Advertisement
XT-2 Reader Installation Manual & Data Sheet
4.2 Trouble Shooting
Caution!
If the reader malfunctions, contact TagMaster Technical Support (see section 6,
"Contact" for details). Never try to dismantle any components inside the reader, since
there are no user serviceable parts inside the reader. Any unauthorized alterations to
the reader will invalidate the warranty.
Three system status indicators on the controller board inside the reader show the
status of the unit (see section 5.1, "Reader Overview" for information on placement).
The table below explains the meaning of the different indicators.
Table 1 System status indicators
Colour
Yellow
Green
Red
The following table describes the most common problems encountered during
installation and proposed solutions.
Table 2 Most common problems
Problem
Yellow system status
indicator is off
Green system status
indicator is on or off
Red system status indicator
is on or off
© TagMaster
Mode
On
Off
Flashing
Initially on
Persistently on/off
Flashing
On
Off
Solution
Check the power supply.
Switch off the power supply, switch it on again, and
wait 30 seconds. This can be done by pulling the J31
terminal block off the board and putting it back again.
If the reader fails to start again, contact TagMaster
support.
Switch off the power supply and switch it on again.
This can be done by pulling the J31 terminal block off
the board and putting it back again. If the reader fails
to start again, contact TagMaster support.
Indicates
Power on
Power off
System SW running
System SW loading
System SW fault
HW initiated and running
Initiation process
HW not initiated
Doc no. 10-407 02
12 (26)
Advertisement
Table of Contents
