Table of Contents
Advertisement
XT-2 Reader Installation Manual & Data Sheet
3.3 Mounting the Reader
Mount the reader in a horizontal position with the cable glands on the bottom side.
Direct the reader so that the reading lobe covers the positions of the ID-tags.
For optimal performance, tilt and rotate the reader into a position so that the front side
of the reader is parallel with the front side of the ID-tag to be read. Align the reader so
that the actual reading range is 60–70% of the specified maximum.
The figure below shows a typical reader installation. Note that the installation details
depend on site requirements.
Figure 2 Reading lobe
How to mount the ID-tag depends on the type of tag and which object that is being
tagged. TagMaster's windshield ID-tag should be mounted in a horizontal position in
the windshield. Note that some cars have a metallized windshield. The ID-tag must be
mounted in an area of the windshield without metallization.
Warning!
To comply with Council Recommendation 1999/519/EC, it is recommended that the
reader is installed so that a separation distance of at least 20 cm (8 in) from all persons
is provided.
The XT-2 Mounting Kit (Part No. 194900) from TagMaster enables the reader to be
mounted in a wide variety of positions and angles. The kit contains all parts needed for
mounting the reader on a wall or on a pole. The XT-2 Mounting Kit is suitable for both
indoor and outdoor use.
© TagMaster
=
Doc no. 10-407 02
=
TM00103
8 (26)
Advertisement
Table of Contents
