Interfaces - TagMaster XT-2 Installation Manual & Data Sheet

XT-2 Reader Installation Manual & Data Sheet
5.2

Interfaces

5.2.1 Connector Overview
For easy installation and service the cables are screwed into removable block
connectors.
1 2 1 2 3
J1
Figure 5 Connector overview
Note: It is possible to attach or remove the terminal block connectors inside the reader
for more convenient connection of the cables.
The terminals are grouped as specified in the sections below.
5.2.2 Relay Output, Group J1
The controller board has one relay output.
Table 3 Relay Output, Group J1
Pin
1
2
3
5.2.3 Wiegand/Mag-stripe, Group J2
The controller board has an access control interface that supports both Wiegand and
Mag-stripe protocols.
© TagMaster
3 4 5 6 1 2 3 4 5 1 3 4 2
J51 J52 J31 J32
Signal Description
RCOM Common terminal
ROPEN Connected to RCOM when relay is open
RCLOSE Connected to RCOM when relay is closed
P1
1 2 1 3 4 2 1 2 3 4 5
J2 J41
Doc no. 10-407 02
P2
P3
1 2 3 1 2 3
J42 J43
TM00107
14 (26)