European Hazardous Location Approval - Allen-Bradley 1734-OE4C Installation Instructions Manual

European Hazardous Location Approval

The following applies when the product bears the Ex Marking
This equipment is intended for use in potentially explosive atmospheres as defined by European Union
Directive 94/9/EC.
DEMKO certifies that this equipment has been found to comply with the Essential Health and Safety
Requirements relating to the design and construction of Category 3 equipment intended for use in Zone
2 potentially explosive atmospheres, given in Annex II to this Directive.
Compliance with the Essential Health and Safety Requirements has been assured by compliance with
EN 60079-0:2012+A11:2013, EN 60079-15:2010, reference certificate number DEMKO
04ATEX0330347X.
WARNING: This equipment shall be mounted in an ATEX certified enclosure
with a minimum ingress protection rating of at least IP54 (as defined in
IEC60529) and used in an environment of not more than Pollution Degree 2 (as
defined in IEC 60664-1) when applied in Zone 2 environments. The enclosure
must utilize a tool removable cover or door.
WARNING: This equipment shall be used within its specified ratings defined
by Rockwell Automation.
WARNING: Provision shall be made to prevent the rated voltage from being
exceeded by transient disturbances of more than 140% of the rated voltage
when applied in Zone 2 environments.
WARNING: This equipment must be used only with ATEX certified Rockwell
Automation backplanes.
WARNING: Secure any external connections that mate to this equipment by
using screws, sliding latches, threaded connectors, or other means provided
with this product.
WARNING: Do not disconnect equipment unless power has been removed or
the area is known to be nonhazardous.
ATTENTION: If this equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may be impaired.
ATTENTION: This equipment is not resistant to sunlight or other sources of
UV radiation.
POINT I/O 4 Channel Analog Current Output Module
Publication 1734-IN034C-EN-E - August 2016
5