Section 7 - Adding Or Changing A User Code - Assa Abloy DK-16 Manual

in the program mode). Enter 00 (or 000 on expanded versions) followed by your 5
to 7 digit Program Code. Do not pause between keystrokes. Wait for the Red LED
(or Green LED if the Reverse Light Logic is turned on) to flash twice indicating that
your code has been accepted. The Yellow LED will begin rapidly flashing again and
if you wish to end programming push the Bell Key on the DK-26 (or push the * or #
key on the DK-16).
If you do already have a Program Code in your Digital Keypad and just wish to
change the code then all you need to do is enter the Program code on the keypad
followed by the Bell Key (or * or # key on the DK-16). The Yellow LED will begin to
rapidly flash (indicating that you are in the program mode). Enter 00 (or 000 on
expanded versions) followed by your new 5 to 7 digit Program Code. Do not pause
between keystrokes. Wait for the Red LED (or Green LED if the Reverse Light Logic
is turned on) to flash twice indicating that your code has been accepted. The
Yellow LED will begin rapidly flashing again and if you wish to end programming
push the Bell Key on the DK-26 (or push the * or # key on the DK-16).

SECTION 7 - ADDING OR CHANGING A USER CODE

Before entering any codes – A quick caution regarding code "sub-sets". Your
Digital Keypad will not let you enter a code that is a sub-set of a previously entered
code. For example if you already have a code entered such as "1-3-3-5-8" and
then attempt to enter "3-3-5" in another address location you Digital Keypad will
reject the attempt. The Digital Keypad will indicate this rejection to you by
illuminating a long single flash on the Red LED (or the Green LED if Reverse Light
Logic is used). (see the section 3 -WHAT ARE THOSE LED's TELLING ME?) It is
advisable to keep a log of your various codes to avoid this problem by denoting
which code is stored in which address. We have created a blank form for you and it
is available by contacting us here at Securitron Technical Support.
If you do not already have a Program Code in you Digital Keypad or don't
remember the one that you have we highly suggest that you enter one now (see
above) before adding or changing a User Code. However, it is not absolutely
necessary to have a Program Code in order to make the change to your User
Codes. If you do not already have a Program Code in your Digital Keypad and
simply wish to add or delete a User Code you must locate the CPU board. On the
printed circuit board (see Figure 2) locate the two small buttons located in one
corner. Push and hold for one second the push button labeled "PRMG CODE".
Quickly return to the keypad (as the function will time out in thirty seconds). The
Yellow LED will be rapidly flashing (indicating that you are in the program mode).
With the standard DK-16 or DK-26 you can have up to 59 User Codes. The
Released: 8/27/2009
Securitron Magnalock Corp.
SD-04 Rev. A