Engine/Generator Parameter - Procom ECON-F Installation Manual

Sensor 1: Warning
Open 2:Fault
3: Disabled
Pulses/Re 1-300
volution
Start Stop 1: Separate
Config keys
2: Only Start
key
B.
All the Engine programmable parameters are listed below along with their
default value and minimum / maximum variation range. Values can be
increased or decreased by pressing up/start and down/stop button
respectively . Next parameter can be selected by pressing next button.
Operating Instructions
The action to be taken if the
sensor is found to be open.
No of pulses, from Magnetic
Pickup unit or W point of
charging alternator, in one
revolution of the engine. This
shall be used to calculate the
RPM.
This parameter decides as to
how the remote start and stop
shall be done. Option 1:
Separate keys is selected
than a single pulse on remote
start shall the engine and
another pulse on remote stop
shall stop the engine. The
duration of these pulses
shall be more than 200msec.
Option 2: In this option the
engine shall be stated and
kept working till Remote start
is pulled low. As soon as the
pin is released the engine
shall stop. To attempt a new
start cycle, after the engine
fails to start, the remote start
pin must be released for some
time and again pulled low.
* Option 2 should not be
selected if the start and stop
functions are to be executed
from front keys.

Engine/Generator Parameter

Warning
132
Separate
keys
Page - 8