Assembly Instructions - Landa MVC4-3000 Operator's Manual

STEP 1: Attach a 5/8" garden hose
to inlet connector. Minimum flow
should be 5 gpm.
Dipstick
STEP 4: Check oil level on sight
glass on side of pump. Oil should be
visible one-half way up sight glass
(SAE 30W non-detergent). The oil
level can also be checked by using
the dipstick on the top of the pump.

ASSEMBLY INSTRUCTIONS

STEP 2: Attach high pressure hose
to discharge nipple using quick cou-
pler. Lock coupler securely into place
by pulling back coupler collar and in-
serting it onto discharge nipple, then
pushing collar forward to lock in place.
Engine
Fuel
Burner
Fuel
STEP 5: Fill gasoline tank and check
engine oil. Fill fuel tank. Do not con-
fuse gasoline and fuel oil (diesel)
tanks. Keep proper fuel in proper
tanks.
96-61836 • LANDA MVC • REV. 11/04
Safety
Latch
STEP 3: Attach wand to spray gun
using teflon tape on threads to pre-
vent leakage. Attach swivel connec-
tor on discharge hose to spray gun
using teflon tape on threads. Attach
swivel connector on high pressure
hose to spray gun using teflon tape
on threads. Engage safety latch to
prevent from triggering gun.
STEP 6: Install proper battery mak-
ing sure that the red cable is at-
tached to the positive terminal. Use
only a group 24 marine type deep
cell battery with a 90 amp hour rat-
ing (battery not included). This is for
electric start models only.
Caution: These machines are in-
tended to be protected from outside
environments.
7