Page 1
I MVC4-30321 I MVC4-30321E I MVC4-30321E/S I MVC4-35321E ® LANDA, INC. 4275 N.W. Pacific Rim Blvd. Camas, WA 98607 For technical assistance or the Landa Dealer nearest you, call 800-LANDA-4-U (800-526-3248) or (360) 833-9100 or consult our web page at www.landa.com...
5. Risk of explosion - do not spray Landa, Inc. reserves the right to make changes at any flammable liquids or operate in time without incurring any obligation. an explosive location. Operate...
29. CAUTION: Risk of injury. Disconnect battery tion and knowledge of the machine. ground terminal before servicing. 14. Landa will not be liable for any changes made to our PRE-OPERATION CHECK standard machines, or any components not pur- chased from Landa.
When the engine starts, allow the engine switch to return to the ON position. If the engine is to 12vDC burner will result. LANDA MVC • #96-61836 • REV. 5/03...
7. When you finish washing, rinse by simply turning The machine can siphon and mix de- MAY BE HARMFUL IF the variable pressure wand control handle clockwise tergents with the use of Landa's de- INHALED OR to increase pressure. INGESTED.
#9-028008) will remove lime and other deposits before and dry. coil becomes plugged. (See Deliming Instructions for use The areas around the Landa washer should be kept clean of Landa Deliming Powder.) and free of combustible materials, gasoline and other Deliming Coils: flammable vapors and liquids.
Page 10
Fuel (See illustration below.) Pump Electrodes 5/32" Gap 5/32" In Line Filter 1/4" 1/2" 2-7/8" 5/32" Nozzle Adapter Top View Side View Periodically check wiring connections. If necessary to adjust electrodes, use diagram. LANDA MVC • #96-61836 • REV. 5/03...
Page 11
For such motors to run properly, the battery and engine charging system must be kept in good condition, and the engine must run fast enough to adequately charge the battery. Do not throttle down the engine for any length of time. LANDA MVC • #96-61836 • REV. 5/03...
MVC SERIES PRESSURE WASHER OPERATOR’S MANUAL ALL MODELS EXPLODED VIEW LEFT SIDE LANDA MVC • #96-61836 • REV. 5/03...
Page 13
MVC SERIES PRESSURE WASHER OPERATOR’S MANUAL ALL MODELS EXPLODED VIEW RIGHT SIDE Detail See Control Box Illus. Rectifier (Reversed View) LANDA MVC • #96-61836 • REV. 5/03...
Attention to regular preventative mainte- nance procedures will assist in preserving the performance of your equipment. Contact your Landa, Inc. dealer for maintenance. Regular preventative maintenance will add many hours to the life of your pressure washer. Perform maintenance more often under severe conditions.
12V DC relay defective Test and replace. Fuel is not reaching combustion Check fuel pump for proper flow. Check chamber solenoid flow switch on machines with spray gun control for proper on-off flow control. LANDA MVC • #96-61836 • REV. 5/03...
Page 22
Check and replace if necessary. IN OIL Air humidity is high Check and change oil twice as often. Packing is worn or bad Check and replace if necessary. (For parts or information contact your local LANDA dealer) LANDA MVC • #96-61836 • REV. 5/03...
Page 23
Check and replace or tighten wiring. Burner motor is defective Replace motor. RELIEF VALVE Relief valve is defective Replace or repair relief valve. LEAKS WATER (For parts or information contact your local LANDA dealer) LANDA MVC • #96-61836 • REV. 5/03...
TICULAR PURPOSE. LANDA does not authorize any other party, including authorized LANDA Dealers, to make any represen- tation or promise on behalf of LANDA, or to modify the terms, conditions, or limitations in any way. It is the buyer’s responsibility to ensure that the installation and use of LANDA products conforms to local codes.
® WATER CLEANING SYSTEMS 4275 NW Pacific Rim Blvd. • Camas, WA 98607 USA Form #96-61836 • Revised 5/03 • Printed in U.S.A. by Landa, Inc., Camas, WA 98607...