Cleaning And Care - Silvercrest SEM 1100 A2 Operating Instructions Manual

Cleaning and Care

■ Always remove the plug from the mains power socket before you clean the
appliance. Risk of electric shock!
■ Always allow the appliance to cool down before you start to clean it. Risk of
Burns!
■ NEVER submerse the appliance in water or other liquids. Risk of electric shock!
Cleaning the milk frother
ATTENTION - PROPERTY DAMAGE
■ NEVER use abrasive, corrosive or chemical agents to clean the appliance.
These could damage the upper surfaces of the appliance.
1) Place an empty container under the milk frother z.
2) Immediately after use turn the steam control knob 2 to the position "+ " and,
for a few seconds, allow the steam to escape.
3) Turn the steam control knob 2 off (as far as it will go in the direction "-"),
switch the appliance off and remove the plug from the mains power socket.
4) Allow the nozzle to cool down.
5) Remove the nozzle and clean it thoroughly in warm water.
6) Check to see if the small hole in the nozzle is clogged and, if so, clear it with
a needle.
7) Clean the steam delivery tube of the milk frother z with a damp cloth.
8) Replace the nozzle back onto the steam supply pipe.
SEM 1100 A2
WARNING - RISK OF INJURY!
GB
CY
15