Terminal Selection Programming - Welch Allyn scanteam 3400 series Operating Manual

If you've already programmed the 3400 using "Plug and Play"
(Section 2.2), you don't need to continue programming the 3400.

2.3 Terminal Selection Programming

Use this section to program the 3400 to work with any
supported terminal or computer.
Programming Instructions
To program the SCANTEAM 3400 using the Terminal
Selection menu :
Locate the two–digit terminal I.D. number for your terminal
or computer on the Supported Terminals chart (page
2–14).
Scan the "Program Terminal Interface" bar code found on
the Terminal Selection menu (page 2–14).
Quick Start Programming
2–11