Faults - Kärcher BD 38/12 C Bp User Manual

DANGER
Risk of injury. Turn the appliance
switch to "0" and pull the mains plug of
the charger prior to performing any
work on the appliance.
Fault
Appliance cannot be started Switch on the appliance switch, wait 3 seconds,
Insufficient water quantity
Insufficient vacuum perfor-
mance
Insufficient cleaning result
Brush does not turn

Faults

ATTENTION
Risk of damage for the appliance due
to leaking water. Drain the wastewater
and remaining fresh water prior to per-
forming tasks on the appliance.
In case of faults that cannot be reme-
died using the table below please con-
tact the customer service.
Remedy
check charge condition of the battery.
Check fresh water level, refill tank if necessary.
Switch on "Detergent" button.
Open the dosing device for the cleaning solution.
Clean the fresh water filter.
Lower the vacuum bar.
Empty the waste water tank.
Clean the seals between waste water tank and cover
and check for tightness, replace if required.
Clean the vacuum lips on the vacuum bar, turn or re-
place if required
Check if the suction hose and vacuum bar are
chocked, clean if required
Check the suction hose for tightness; replace if re-
quired.
Check the brush type and the detergent for their suit-
ability.
Check the brushes for wear, replace if required.
Pull the safety switch towards the steering wheel.
Check the brush for blockage by foreign objects; re-
move the foreign objects.
Switch off the switch for the brush drive, wait for a
short period of time, switch the switch back on.
– 13
EN 15