Installing The Cassette Heaters (Option) - Kyocera PF-760 Service Manual

1-2-3

Installing the cassette heaters (option)

Installing the cassette heater requires the following component:
Cassette heater set: for 220 - 240 V specifications
Supplied parts of cassette heater set:
Two (2) cassette heaters (P/N AVGR02967B): for 220 - 240 V specifications
Two (2) cassette heater retainers
Six (6) M4 x 6 IT tap-tight (S-tight) screws
One (1) relay wire
Nine (9) wire saddles
Procedure
1. Remove two screws from each of the right
cover and left cover 4 and then the covers.
2. Remove three screws holding the paper
feeder rear cover and then the cover.
3. Open the paper feeder.
4. Remove two screws holding the paper con-
veying unit assembly and then the assem-
bly.
5. Fit the cassette heaters to the cassette
heater retainers using two screws and wire
saddle for each.
6. Fit the cassette heater retainers to the left
and right of the paper feeder using one
screw for each.
Cassette heater
Wire saddle
Cassette heater
retainer
7. Pull the cassette heater cable out to the
machine rear through the cable hole.
Y112030-5
Screws
Screw
Machine left
Figure 1-2-3
Service Manual
Paper conveying
unit assembly
Figure 1-2-2
Cassette heater
Screws
Screw
Cassette heater
retainer
Machine right
5H8
Screw
Screw
Wire saddle
1-2-3