I/O Interface Connections - Kontron F632 User Manual

5.3.

I/O Interface Connections

For both the factory installed I/O interface variants (F632, F642 and F655) and externally connect I/O Interface variant
(F65), the following interfaces are available:
 1x Display Port (DP)
 1x DVI
 1x USB 2.0 (Type A) – only for IR-touch variant
For the factory installed I/O interface Full metal variants (F632, F642 and F655) the requested I/O interfaces are lead
out of the housing using two (IP65) three-hole lead-throughs on the rear side of the housing and externally available
for direct use. Because the cables are internally connected, the cable is partially within the housing and the full cable
length is not available for external use. The available external cable length is the original length minus approximately
0.3 m. This reduction in usable cable length must be taken into consideration when ordering the I/O cables.
To ensure the required cable length for the application, the reduction in the usable cable
length must considered when ordering the I/O cables.
For the externally connect I/O Interface variant (F65) the interface connectors are available for direct user connection
on the underside of the back panel, see Table 8: Back Panel Mechanical Features – 65" Displays. Because the I/O cables
and power cable are externally connected, the full cable length is available for external use
For more information on the possible cable length, see Chapter 3.2: Product Variants or contact your local Kontron sales
representative or Kontron Inside Sales.
When disconnecting any power cable or I/O interface cables, do not pull the cable by
grabbing the cable itself. Hold the cable connector whenever disconnecting a cable.
www.kontron.com
FlatView XXL Monitor – User Guide Rev. 1.0
// 25