Table 8: Back Panel Mechanical Features - 65" Displays - Kontron F632 User Manual

Back Panel View
42"
55"
The 65-inch back panel is a full metal solution with externally connected I/O interfaces and power connector with
switch. For this solution, the cables are not lead out of the housing. The I/O connectors are user installed. If required the
I/O area can be assembled with a dust and dirt cover including two lead throughs to lead the cables out of the I/O area
and ensure that the I/O area is not exposed to dust and dirt. The following table shows the position of the main
features.
Table 8: Back Panel Mechanical Features – 65" Displays
Back Panel View
6
7
5
www.kontron.com
1
4
2
3
Features
Rear side
 8x VESA mounting holes (M6) safety eyelet 13 mm maximum
depth
 1x OSD Control Panel keypad
 2x cable lead through (standard - 3 hole lead through)
 Power switch and ground
Top Side
 3x barrel hinges
 4x VESA mounting holes (M8) with safety eyelet 15 mm
maximum depth, to hang the system
Bottom Side
 3x locking screws
Rear side
 14x VESA mounting holes (M6) safety eyelet 13 mm maximum
depth
 1x OSD Control Panel keypad
 2x cable lead through(standard - 3 hole lead through)
 Power switch and ground
Top Side
 4x barrel hinges
 4x VESA mounting holes (M8) with safety eyelet 15 mm
maximum depth, to hang the system
Bottom Side
 Locking screws
Features
Rear side
1. 4x handgrips
2. 16 VESA mounting holes (M6)
3. 1x OSD Control Panel keypad
4. I/O connector panel
5. Power connector and power switch
Top Side
6. 2x VESA mounting holes (M8) to hang the system horizontally
Side
7. 2x VESA mounting holes (M8) to hang the system vertically
FlatView XXL Monitor – User Guide Rev. 1.0
// 24