Fender Assembly And Parts Breakdown - Demco Gravity Flow 550 User Manual

13
10
1
6
15
Mount Inner Fender Supports (11 & 12) to the inside
of the plastic fenders. On the Front, the overlap of the
plastic fender mounts to the cross strap of the inner fender
support. On the Rear, the overlap of the plastic fender
does not mount to the cross strap of the inner fender
support.
Mount the Fender Mounts (9 & 10) to the corner posts.
(Follow directions on following page)
Mount Cross tube (13) to bottom of sill tubes of wagon
using the clamp bar (14) and 4 3/8"X5" bolts (5). Clamp
bar mounts between the sill tubes. Do not tighten bolts
yet. Be sure cross tube is assembled in the right direction.
Refer to detail A above.
Attach Fenders with inner supports to mounting brackets
and cross tube. Adjust cross tube (13) front to back so
fender misses tire when turning. Tighten mounting bolts.
fender Assembly on 550-750 Gravity flow Wagons
5
14
6
4
7
6
16
11
3
6
6
3
14
13
2
1
6
Ref. PART
No.
1. 00372
02592
2.
02802
3.
4. 03169
5. 00675
6. 00004
02990
7.
- 12205-30 1 Fender Mount, Slope Side Front (long)
- 12206-30 1 Fender Mount, Slope Side Rear (long)
9. 12207-30 1 Fender Mount, Door Side Rear (short)
10. 12208-30 1 Fender Mount, Door Side Front (short)
11. 12209-30 2 Inner Fender Support, Front
12. 12210-30 2 Inner Fender Support, Rear
13. 12211-30 2 Cross Tube
14. 12212-30 2 Clamp Bar
15. 12213
16. 12214
17. 12215
12216
18.
Page 23
4
5
6
17
2
1
6
detail A
No. qTy. descRIPTIoN
16 5/16"-18UNC x 1 1/2" Hex Head Bolt Gr. 5
8 3/8"-16UNC Nylon Locknut
44 5/16-18UNC Nylon Locknut
18 5/16"-18UNC x 1 1/4" Slotted Bolt
8 3/8"-16UNC x 5" Hex Head Bolt Gr. 5
58 5/16" Flat washer
8 5/16"-18 UNC x 1" Hex Head Bolt Gr. 5
2 Front Fender Half with offset
2 Front Fender Half without offset
2 Rear Fender Half with offset
2 Rear Fender Half without offset
9
1
6
6
7
18
4
6
6
3
12
6
6
3 3
3
6