FineControl LS-20 Operation Manual page 33

*24-Hour Zone (default = NO): (For Burglar sensor)
24-Hour Zone=YES: This Burglar sensor's trigger signal will be processed all the
time regardless of the system's operation mode, either in Arm or Disarm.
24-Hour Zone=NO: This Burglar sensor's trigger signal will only be processed in Arm Mode.
*Guard in Home Mode (PIR default = No, Door Magnet default = Yes): (For Burglar sensor)
Home Mode =Yes: This Burglar sensor will trigger an alarm in Home Mode operation.
Home Mode=No: This Burglar sensor will not trigger an alarm in Home Mode operation, it will
only trigger an alarm in Away Mode operation.
*Pre-warning (default = No): (For Burglar Sensor)
Pre-warning=Yes: When this device is triggered in Arm Mode, it only turns on the
corresponding switches those set by this device for the time set in the "Prewarning Time"
to warn the person who approaching the protected area. (If 24-Hour Zone set, the switches
will turn on anytime when this device is triggered.) but won't trigger burglar alarm.
*Warning Beep/Voice Delay (default = Yes): (For Fire, Medical and Special sensors)
Warning Beep/Voice Delay=Yes: If this sensor triggers an alarm, there will be a 30-second
warning beep from the Base Unit before the alarm report procedure starts.
Warning Beep/Voice Delay=No: There is no beep warning. The Base Unit reports the alarm
immediately when there is an alarm triggered by this device.
*Alarm with Siren (default= Yes, only No for Controller): (For all devices)
Alarm Siren=Yes: The External Alarm Siren and Wireless Remote Siren will go off when there is
an alarm triggered by this sensor after the Delay time passes.
Alarm Siren=No: The sirens will keep silent when there is an alarm triggered by this device.
*Bell In Disarm (default = No): (For Burglar sensor)
Bell In Disarm=Yes: In Disarm Mode, the Base Unit will issue a bell beep when receiving a
trigger signal from this sensor if the "Door Bell" setting is set to "ON".
Bell In Disarm=No: Doorbell beep will not sound when receiving a trigger signal from this
sensor.
Suggestion: This state should be switched on for the Door Magnet sensors on the front and back doors.
Note: The "Door Bell" must also be turned on.
*Inactivity (default = No): (For Burglar Sensor, disabled in "Away" mode)
Inactivity=Yes: This Burglar Sensor is assigned as an Inactivity Sensor to monitor the activity
of an elderly or physically challenged person. If no activity has been detected during the preset
32