Settings For Timers - FineControl LS-20 Operation Manual

25

8.2 Settings for Timers

*Entry Delay ( For Burglar Sensor only, 0-255 seconds, default =10 sec.)
This setting is the time between any burglar sensor triggers and the alarm action procedure starts.
When you return home and open the door, the Base Unit will issue warning beeps (if the Delay
Activation = On) to remind you that the system is still in the Arm state and you should disarm the
system within this time.
For the system controlled by Wireless Keypad, this timer should be set more than 20 seconds.
Burglar Alarm →
AWAY Mode Entry Delay
System status:
↑ ↑
(0-255 seconds)
Burglar sensor triggered Siren goes off, alarm reporting---
This Delay only works on the Burglar Sensor with its Delay Activation= Yes, see below.
*Exit Delay (for Controller only, 0-255 seconds, default =10 sec.)
This setting is the time between selecting the "AWAY" mode and when the "AWAY" arm
becomes effective. During this time, the Base Unit will issue warning beeps to remind the
people still in the house to leave as soon as possible.
Since the Door Open signal may last for 10 seconds, so add 10 seconds to the time you need to
leave the house as the Exit Delay. (Ex. you need 20 seconds to leave the house, set Exit Delay=30s)
For the system controlled by Wireless Keypad, this timer should be set more than 20 seconds.