8, Control And Parameter Settings; Control - FineControl LS-20 Operation Manual

8. CONTROL AND PARAMETER SETTINGS

8.1 Control

* Siren Test: This test will activate the beeper, external alarm siren and send an Activate signal
to the Remote Siren (if a remote siren is installed) immediately.
(HyperSecureLink)
* Clear Status: To Clean the alarm/ warning LED and stop the alarm/ warning reaction.
(HyperSecureLink)
* Device Test: Enter into Device Test Mode for 5 minutes. Any trigger signal (not including the
control signal from Remote Controller) in this time will be treated as a test signal.
After 5 minutes, the system will exit from this mode automatically.
* External Alarm Siren: On: turn on the wire siren circuit on the rear panel.
* Control Command Password: (default = Disable)
Disable: No password needed for the control commands.
Enable: Password must be attached to the control commands.
(If "Enable" then the password must be set and submitted when running the
HyperSecureLink software as below.)
(Livingpattern Cloud Service)
(Livingpattern Cloud Service)
Off: turn off the wire siren circuit on the rear panel.
24
(MyHome App.)