Camera - HP EliteOne 1000 G1 Maintenance & Service Manual

Camera

To replace the camera:
1. Prepare the computer for disassembly (see
2. Insert a paper clip into the release holes on each side of the camera (1) to disengage the internal
latches, and then pull the camera out of the display head (2).
3. Insert the new webcam into the camera slot on the display head and press the webcam down so that it
engages the internal latches.
4. Reconnect the power cord and any external devices, and then turn on the computer.
To install a webcam when a camera blank is installed in the camera slot on the display head:
1. Prepare the computer for disassembly (see
2. Remove the display head rear panel (see
32 Chapter 4 Removal and replacement procedures
Preparing to disassemble the computer on page
Preparing to disassemble the computer on page
Display head rear panel on page
17).
17).
31).