HP EliteOne 1000 G1 Maintenance & Service Manual page 97

Control panel message
302-Hard Disk 2: SMART Hard Drive Detects
Imminent Failure
309 – 30C: Hard Disk 3–6: SMART Hard Drive
Detects Imminent Failure
3F0–Boot Device Not Found
3F1–Hard Disk 1 Error
3F2–Hard Disk 2 Error
400-Serial Port A Address Conflict Detected
41B-Device in PCI Express Slot Failed To
Initialize
43A-USB Type-C I2C Not Connected
43B-More Than One USB type-C Cards Are
Installed
500–BIOS Recovery
70x-Wireless Mode Not Supported
800-Keyboard Error
Description
Hard drive is about to fail. (Some hard drives
have a hard drive firmware patch that will fix an
erroneous error message.)
Hard drive is about to fail. (Some hard drives
have a hard drive firmware patch that will fix an
erroneous error message.)
Boot device not found.
Hard disk 1 error.
Hard disk 2 error.
Both external and internal serial ports are
assigned to the same resources.
There is an incompatibility or problem with a
PCIe device and the system or PCIe link could
not be configured to a valid bus width or speed.
Cable is required between I2C on card and USB-
C on the system board.
More than one USB type-C card is installed.
A system BIOS recovery has occurred.
The system has detected a wireless module
installed in the system that is not supported
and has been disabled.
Keyboard failure.
Recommended action
1. Determine if hard drive is giving correct
error message. Run the Drive Protection
System test under using F2 Diagnostics
when booting the computer.
2. Apply hard drive firmware patch
if applicable. (Available at
http://www.hp.com/support.)
3. Back up contents and replace hard drive.
1. Determine if hard drive is giving correct
error message. Run the Drive Protection
System test under using F2 Diagnostics
when booting the computer.
2. Apply hard drive firmware patch
if applicable. (Available at
http://www.hp.com/support.)
3. Back up contents and replace hard drive.
Insert boot device or load operating system.
1. Check and/or replace cables.
2. Clear CMOS. (See Password security and
resetting CMOS on page
3. Replace the hard disk drive.
1. Check and/or replace cables.
2. Clear CMOS. (See Password security and
resetting CMOS on page
3. Replace the hard disk drive.
1. Remove any serial port expansion cards.
2. Clear CMOS. (See Password security and
resetting CMOS on page
3. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
Try rebooting the system. If the error reoccurs,
the device may not work with this system
Install cable between I2C on card and USB-C on
the system board.
Remove USB type-C card so only one is
installed.
Not applicable.
Replace with a supported module.
1. Reconnect keyboard with computer
turned off.
2. Check connector for bent or missing pins.
POST numeric codes and text messages
93.)
93.)
93.)
89