Display Head - HP EliteOne 1000 G1 Maintenance & Service Manual

Display head

The display head can be replaced or upgraded to a different display.
1. Prepare the computer for disassembly (see
2. Remove the base unit rear access cover (see
3. Disconnect the two display cables attached to the system board by squeezing inward on the two ends of
the cable connectors (1) and pulling the cable connectors up and off the system board (2).
4. Remove the cables from the clip (3).
5. As shown in the following illustration, loosen the two captive screws at the base of the display head's
neck (1). While holding onto the bottom of the display head from the front with one hand, slide the
display head back with your other hand to clear it from the small metal retention tab, and then lift the
display off the base (2).
IMPORTANT:
removing it to prevent the display head from falling over and being damaged.
To replace the display head, reverse the removal procedures.
20 Chapter 4 Removal and replacement procedures
The display head is heavy. Make sure you are holding the display head firmly when
Preparing to disassemble the computer on page
Base unit access covers on page
17).
18).