Hard Drive - HP EliteOne 1000 G1 Maintenance & Service Manual

Hard drive

To locate the hard drive on the system board, see
1. Prepare the computer for disassembly (see
2. Remove the base unit rear and front access panels (see
3. Pull the release lever at the front of the drive outward (1).
4. Slide the drive back until it stops and lift it out of the drive bay (2).
5. Disconnect the cable from the rear of the hard drive (3).
6. Remove the four mounting screws from the sides of the hard drive that was removed.
26 Chapter 4 Removal and replacement procedures
Internal components on page
Preparing to disassemble the computer on page
Base unit access covers on page
21.
17).
18).