Login At The Access Point - Hypercom Optimum M4240 Quick Reference Manual

Login at the access point

Necessity of a login
The terminal must be logged in at the access point in order to use it. This procedure is known
as `pairing´.
If you receive the terminal from B+S at the same time as the access point, we will already have
performed pairing for you. You simply need to connect the terminal and the access point.
Please perform the initial commissioning of the terminal.
If you receive the terminal without an access point (as a result of an additional terminal being
requested, a supplementary delivery or a replacement following a fault), please perform initial
commissioning of the terminal, then carry out the pairing procedure described below for the
access point that you already have.
The terminal can only be logged in at one access point!
Power supply Access Point
Serial port
Manual pairing
Connect access point
to terminal via
connecting cable
Key Enter
merchant
Best
password
Key
Best
Cable connection
Abbr
Press the key repeatedly until `Please enter amount´ appears on the display.
or or
LINE
NET ISDN
Pairing connecting cable
Switch on Key
terminal
Menü
Key
Best
System files
Key Please wait
Best
Assignment
is made
4
Key
Administration
Key Key
Best Best
RAS/BT functions
remove
connecting
cable
Bottom of terminal
Key Key
Best
Merchant
Key
BT login
Key
Best
17