Installing And Removing Plastic Drive Covers - Fujitsu Siemens Computers Esprimo C Operating Manual

Installing and removing plastic drive covers

Removing plastic drive cover
When you install an accessible drive in an empty bay, you must first remove the plastic drive cover.
► Open the casing (see "Opening the casing").
► Lay the casing cover accessibly on a non-slide surface.
Do not throw away the safety covers. If you remove the drive again later, you must reinstall
!
the covers (cooling, fire protection or EMC regulations to be complied with).
Installing plastic drive cover
Depending on the drive (e.g. DVD drive), you must reinstall the plastic drive cover.
a b c
A26361-K1009-Z120-1-7619, edition 4
► Press the latches of the relevant plastic
drive covers lightly out forwards and pull
the covers forward out of the front cover.
a = Cover for optical drive
b = Cover for module bay
c = no drive
► Set the drive cover in the direction of the
arrow into the front panel and press the
latches lightly into the respective brackets.
► Close the casing (see "Closing the casing").
System expansions
43