Reset To Factory Defaults - Technicolor TG788v v3 Setup And User Manual

8.4 Reset to factory defaults

Resetting your TG788v v3
If at some point you can no longer connect to the TG788v v3 or you want to make a fresh install, it may be useful to perform
a reset to factory defaults.
A reset to factory default settings deletes all configuration changes you made. Therefore, after the reset a
reconfiguration of your TG788v v3 will be needed.
Also your wireless clients will have to be re-associated, as described in
Methods
You can choose between:
• Resetting the TG788v v3 via the web interface
• Reset the TG788v v3 via the Reset button
Resetting the TG788v v3 via the web interface
Proceed as follows:
1 Browse to the
For more information, see
2 Click Gateway. The Gateway page appears.
3 Click Reset.
4 The TG788v v3 restores the factory default configuration and restarts.
Reset the TG788v v3 via the Reset button
Proceed as follows:
1 Make sure the TG788v v3 is turned on.
2 Push the Reset button for at least 7 seconds and then release it.
3 The TG788v v3 restarts.
Your system administrator may have disabled the physical reset button of the TG788v v3. In this case, a hardware
reset to defaults is not possible.
Restore your settings
If you previously backed up your configuration, you can now restore this configuration on your TG788v v3.
For more information, see
DMS3-CTC-25-281 v2.0
TG788v v3 web interface.
"4.1.1 Accessing the TG788v v3 web interface from your local network" on page
"4.4 Backing up/restoring your configuration" on page
"3 Wireless networking" on page
Reset
56.
8 Support
22.
33.
77