Table of Contents
Advertisement
2.3 Installing Dynamic C
If you have not yet installed Dynamic C version 7.26P (or a later version), do so now by
inserting the Dynamic C CD in your PC's CD-ROM drive. The CD will auto-install unless
you have disabled auto-install on your PC.
If the CD does not auto-install, click
browse for the Dynamic C
installation once you have selected the
The Dynamic C User's Manual provides detailed instructions for the installation of
Dynamic C and any future upgrades.
NOTE: If you have an earlier version of Dynamic C already installed, the default instal-
lation of the later version will be in a different folder, and a separate icon will appear on
your desktop.
2.4 Starting Dynamic C
Once the LP3500 is connected to your PC and to a power source, start Dynamic C by dou-
ble-clicking on the Dynamic C icon or by double-clicking on the
with
in the Dynamic C directory.
DcRab
Dynamic C assumes, by default, that you are using serial port COM1 on your PC. If you
are using COM1, then Dynamic C should detect the LP3500 and go through a sequence of
steps to cold-boot the LP3500 and to compile the BIOS. If the error message "Rabbit Pro-
cessor Not Detected" appears, you have probably connected to a different PC serial port
such as COM2, COM3, or COM4. You can change the serial port used by Dynamic C with
the
OPTIONS
menu, then try to get Dynamic C to recognize the LP3500 by selecting
Reset Target/Compile BIOS
menu until you find the one you are connected to. If you still can't get Dynamic
OPTIONS
C to recognize the target on any port, then the hookup may be wrong or the COM port
might not working on your PC.
Dynamic C automatically uses a maximum debug baud rate of 38,400 bps when an
LP3500 series board is in use.
14
Start > Run
file on your CD drive. Click
setup.exe
setup.exe
on the
Compile
menu. Try the different COM ports in the
from the Windows
Start
OK
file.
.exe
button and
to begin the
file associated
Fox (LP3500)
Advertisement
Table of Contents
