Exclusion Zone - Z-World Fox LP3500 User Manual

A.1.1 Exclusion Zone
It is recommended that you allow for an "exclusion zone" of 0.25" (6 mm) around the
LP3500 in all directions when the LP3500 is incorporated into an assembly that includes
other printed circuit boards. This "exclusion zone" that you keep free of other components
and boards will allow for sufficient air flow, and will help to minimize any electrical or
electromagnetic interference between adjacent boards. An "exclusion zone" of 0.12"
(3 mm) is recommended below the LP3500. Figure A-2 shows this "exclusion zone."
When using the LP3500 with the Prototyping Board, do not install any components in the
prototyping area on the Prototyping Board between the LP3500 and the Prototyping
Board.
User's Manual
4.15
(105)
3.65
(93)
3.10
(79)
2.60
(66)
Figure A-2. LP3500 "Exclusion Zone"
71