Z-World Fox LP3500 User Manual page 16

3. Attach the LP3500 main board to the Prototyping Board as shown in Figure 3.
Press the headers on the LP3500 series board firmly into the corresponding header sock-
ets located at J1, J2, and J4 on the Prototyping Board.
NOTE: It is important that you line up the header pins on the LP3500 exactly with the
corresponding
pins may become bent or damaged if the pin alignment is offset, and the LP3500 will
not work. Permanent electrical damage may also result if a misaligned LP3500 is
powered up.
J1
J41
J3
3 V VBAT
GND RxE TxE GND RxC TxC
Figure 3. Attach LP3500 Main Board to Prototyping Board
10
header sockets J1, J2, and J4
J2
GND
J4
VIN
J4
R1
J42 J43
GND RxB TxB GND + 485 – GND +K OUT9 OUT8 OUT7 OUT6 OUT5
on the Prototyping Board. The header
RN1
VIN
VIN GND
GND
D1
J44
J5
OUT4 OUT3 OUT2 OUT1 OUT0
Fox (LP3500)