Z-World Fox LP3500 User Manual page 17

4. Connect the programming cable to download programs from your PC and to program
and debug the LP3500.
NOTE: Use only the programming cable that has a red shrink wrap around the RS-232
level converter (Z-World part number 101-0276), which is supplied with the LP3500
Tool Kit. Other Z-World programming cables might not be voltage-compatible or their
connector sizes may be different.
Connect the 10-pin
PROG
board. Ensure that the colored edge lines up with pin 1 as shown. There is a small dot on the
circuit board next to pin 1 of header J5. (Do not use the
monitoring only, as explained in Appendix F, "Programming Cable.") Connect the other
end of the programming cable to a COM port on your PC. Make a note of the port to
which you connect the cable, as Dynamic C will need to have this parameter configured.
Note that COM1 on the PC is the default COM port used by Dynamic C.
J41
X
J3
3 V VBAT
GND RxE TxE GND RxC TxC
Do connect
AC adapter to
terminal
Figure 4. Programming Cable and Power Supply Connections
User's Manual
connector of the programming cable to header J5 on the LP3500
J5
PROGRAM
PORT
PROG
GND
VIN
J4
R1
J42 J43
GND RxB TxB GND + 485 – GND +K OUT9 OUT8 OUT7 OUT6 OUT5
connector, which is used for
DIAG
To
PC COM port
Colored edge
RN1
VIN
GND
VIN
GND
D1
J44
J5
OUT4 OUT3 OUT2 OUT1 OUT0
J5
Red
shrink wrap
11