Table of Contents
Advertisement
2. +K must be connected to an external power supply. A 0 Ω resistor on the Prototyping
Board (R1) ties +K to VIN from the AC adapter and thus satisfies this requirement as
long as the LP3500 is connected to the Prototyping Board.
3. Open
with the
DIGIN.C
it by selecting
Run
4. The following display will appear in the Dyanamic C
5. When pressing pushbutton switches S1–S4 on the Prototyping Board you can change
the inputs for IN0–IN3 from a "1" to a "0."
6. Similarly you can view a change to the inputs for IN0–IN15 from a "1" to a "0" when
you touch a wire connected to ground to IN0–IN15.
130
menu, compile it using the
File
in the
menu.
Run
menu, and then run
Compile
STDIO
window.
Fox (LP3500)
Advertisement
Table of Contents
