Useful Functions - Sony VENICE MPC-3610 Operating Instructions Manual

000 58
4. Shooting

Useful Functions

Simultaneous Recording (Simul Rec)
You can simultaneously record two sizes of
pictures on an SxS memory card in one slot. You
can also simultaneously record an HD signal on an
SxS memory card in the unit while recording video
and audio in RAW format on the AXS-R7.
You can perform simultaneous recording using
Project category > AXS Rec Format and SxS Rec
Format or SxS Rec Format and Sub Rec Format
in the menu as described in "Recording Format
Settings" (page 39).
[Note]
In simultaneous recording mode, the unit cannot switch to
the second card automatically even if a card becomes full.
In 1-slot simultaneous recording, the XAVC 4K
Class480/XAVC 4K Class300/XAVC QFHD Class480/
XAVC QFHD Class300 clip is recorded in the
XDROOT/Clip directory on the SxS memory card,
but the MPEG2 1920×1080 clip is recorded in the
XDROOT/Sub directory on the SxS memory card.
The suffix "S02" is appended to the end of the clip
name.
Recording Review (Rec Review)
You can review the last recorded clip on the
screen by assigning the Rec Review function to
one of assignable buttons 1 to 4 (page 32).
When you stop recording and press the button
assigned with Rec Review, the clip is played at
normal speed starting from the first frame.
The clip is played to the end, then Rec Review
ends and the unit returns to STBY (recording
standby) mode.
If the HOME button is pressed on the Operator
side or Assistant side during playback, playback
stops and the unit switches to shooting mode.
Focus Magnifier Function
By pressing the FOCUS MAG button of the
viewfinder (DVF-EL200, DVF-L700) attached to
the unit, you can expand the center part of the
viewfinder, making it is easier to adjust the focus.
After adjusting the focus, press the button again to
return to the normal (recording) screen.
The magnified display does not affect the recorded
image or output signal.
Viewfinder Double Speed Scan
Function
If the project frame rate is 23.98P, 24P, 25P, or
29.97P, the image may become blurred and hard
to see due to low frame frequency when you
shoot while swaying the unit to the right and the
left.
In this case, you can decrease image blur and
make it easier to see by activating the viewfinder
double speed scan function.
To activate the function, set Monitoring category >
Moni. Details > VF Function > Double Speed Scan
(page 47) in the menu to On.
[Note]
When this function is activated, the shutter angle of the
electronic shutter function is limited to 180 degrees or lower.