Setting The Clock - Sony VENICE MPC-3610 Operating Instructions Manual

000 15 2. Preparation

Setting the Clock

When you use the unit for the first time, the initial
setup screen appears on the sub display when the
power is turned on.
Set the date and time of the built-in clock using
this display.
Time Zone
The value shows the time difference from UTC
(Coordinated Universal Time). Change the setting
if needed.
[Note]
When Time Zone is changed, the clock setting changes
according to the time difference.
Setting the Date and Time
Turn the MENU dial (page 7) to move the
cursor, then press the MENU dial to set each menu
item. When you press the MENU dial when the
cursor is on "Set," the setting display disappears
and the clock setting is completed.
After the initial setup screen disappears, you can
change Time Zone and date/time settings using
Maintenance > Clock Set (page 50) in the full
menu.
[Notes]
ˎ If the clock setting is cleared because the backup battery ˎ
fully discharged when no power was supplied (no battery
pack and no DC IN connection), the initial setup display
will be displayed when you next turn the unit on.
ˎ While the initial setup display is shown, no other ˎ
operation, except turning the power off, is permitted until
you finish the setting for this display.