Table of Contents
Advertisement
Page 8
7. Menu Navigation
7.1. sELECTING a MENU
7.2. CHaNGING VaLUEs
7.3. THE CURsOR
7.4. sTaTUs VaLUEs
When entering the set Up mode, the LCD display switches to the set Up
menu last used, with the cursor on the far left position in the upper line. The
cursor position is indicated with a '>' character, implemented as inverse
video, flashing on and off.
To move to another menu, with the cursor on the upper left position, press the
[
] or [
] key.
up
down
To edit one of the fields on the current menu, press the [
to move the cursor to the desired field. Then, press the [
change the value.
Note that no change will take effect until the [
ing a menu without pressing the [
The cursor position is indicated with a '>' character, implemented as inverse video,
flashing on and off..
after a value is edited, the cursor changes to a solid triangle, until the [ENTER]
key is pressed.
If the cursor is moved to another field without pressing the [
the solid triangle stays in front of the edited field to indicate a change was
made but not entered yet.
Throughout the different menus, values appear in the display enclosed in
square brackets. These are status values.
status values are the values actually obtained, based on a menu selection such
as the output rise time in menu 04.
SR-112 User Manual (Rev 4.01)
] key is pressed. When exit-
enter
] key, the changes are lost.
enter
] or [
] key
right
left
] or [
] key to
up
down
] key first,
enter
Advertisement
Table of Contents
