Table of Contents
Advertisement
Page 20
'Program Error' indicates that an error occurred during the programming step and
the consequences will depend on the type of update:
IMPORTANT:
IF A PROGRAMMING ERROR OCCuRED DuRING A 'COMPLETE' uPDATE AND THE
uNIT IS STILL ON, TRy RuNNING THE PROGRAMMING SEquENCE AGAIN AS
DESCRIBED IN 13.3, WITHOuT CyCLING POWER.
IF POWER IS TuRNED OFF, THE uNIT WILL MOST LIkELy NEED TO BE RETuRNED TO
THE FACTORy.
13.5 LOaDER
The Loader is a fall-back web page that allows you to restore your sR-112 in case
of a programming failure. This page is located in a different area of the Flash
Memory (see LOaDER sOFTWaRE on the Flash Memory map above, 13.2).
To enter the LOaDER mode, hold down the [
powering up and until "sR-112" appears on the display (you don't have to hold
down the power key itself -- a single hit is sufficient).
When the Loader is run, prior to any upload and programming activity, the 7-segment
display will show " LoadEr ", and the following message appears in the LCD:
Point your browser to the IP address of your sR-112. The following page will appear
This page is similar to
the regular Upload page
described above, without
active status updates.
To restore your unit, use
the BROWsE button to
locate the firmware file on
your hard disk (.upld) and
click UPLOaD. The normal
programming sequence
described in 13.3 will follow.
From Loader mode you can
adjust IP addresses and DHCP
mode in the usual way.
- sOFTWaRE UPDaTE: The application software may have become corrupted
but the Loader is intact and can be used to restore the sR-112 (see 13.5).
- COMPLETE UPDaTE: a Programming error during a 'complete' update is most
likely not recoverable via Ethernet and your sR-112 will need to be returned to
the factory for a full restore of its flash memory.
SR-112 User Manual (Rev 4.01)
] and [
] keys while
down
setup
Advertisement
Table of Contents
