Table of Contents
Advertisement
SR-112 User Manual (Rev 4.01)
4. Quick start
You should read this manual to familiarize yourself with the sR-112 features. The
following simple steps are only provided to get you started right away.
NOTE: The SR-112 reshapes and distributes time code. With a software upgrade
(TCG), it also repairs and generates time code. For instructions on those features,
please refer to the TCG manual.
Connect the power supply to the Power a jack and plug the IEC cable into a wall
outlet. Then tap the front panel power switch to turn on your unit (there will be a
small delay, approx. 2 seconds, before the front panel actually turns on).
Connect your time code source to the XLR TC input and, if available, connect
your video reference to the video input BNC. Out of the box, the sR-112 is set to
reshape and distribute your time code source through its 12 outputs. Output levels
are set to 0dBU.
5. Front Panel Displays & LED's
5.1. LCD DIsPLaY - sTaTUs PaGEs
The 32 characters LCD display has 5 different status pages: Time Code In,
Video, User Bits, Video Phase and Errors.
To access these different pages, press the [
• TIME CODE IN
Displays the type of time code (bottom line, left), the format (bottom line,
center) and the rate (bottom line, right).
Time Code formats are 30DF, 30ND, 25 and 24 f/s code.
The rate is displayed via a frequency counter with 3 decimals.
• VIDEO FORMaT
Displays the format and the rate of the video reference.
see appendix B for a list of supported video formats.
• UsER BITs
Displays the User Bits and the User Bits type. see chapter 13 for more info.
• VIDEO PHasE
Displays the phase between time code and the video reference by indicating
the time code bit lined up with Video sync. Ideally it should read '+000.0º'.
see 10.2 for more on video phase.
] or [
] key.
up
down
Page 5
Advertisement
Table of Contents
