Removing The Uplink Port Profiles - Dell EMC VxBlock 240 Administration Manual

2 To modify the UPLINK port profiles for VMware VM traffic, L3 VMotion, NFS, and VSM Layer 3
Control, type the following:
port-profile type ethernet PRODUCTION-UPLINK
vmware port-group
switchport mode trunk
switchport trunk allowed vlan 300
channel-group auto mode on mac-pinning
no shutdown
state enabled
/* For vSphere 6.0 and later */
port-profile type ethernet VMOTION-UPLINK
vmware port-group
switchport mode trunk
switchport trunk allowed vlan <106 or 117>
channel-group auto mode on mac-pinning
no shutdown
system vlan <106 or 117>
state enabled
port-profile type ethernet N1K_L3_CONTROL-UPLINK
vmware port-group
switchport mode trunk
switchport trunk allowed vlan 116
channel-group auto mode on mac-pinning
no shutdown
system vlan 116
state enabled
/* For unified only */
port-profile type ethernet NFS-UPLINK
vmware port-group
switchport mode trunk
switchport trunk allowed vlan 109
channel-group auto mode on mac-pinning
no shutdown
system vlan 109
state enabled
3 to view the uplinks created under the Cisco Nexus 1000V Switch in the production VMware
vCenter, select Inventory > Networking.

Removing the uplink port profiles

Remove the uplink port profiles from the trunks that run northbound from the Cisco Nexus 1000V Switch.
Northbound traffic from the Cisco Nexus 1000V Switch is affected.
Before you begin
•
Verify that VLANs on uplinks exist in Cisco aggregation switches.
119 | Managing the Cisco Nexus 1000V Series Switch