DUMP FUNCTION
The dump function allows the operator to activate
the conveyor to empty the hopper after use or load
material into a walk-behind spreader.
The dump function is a two-handed operation requiring
the operator to press two buttons at the same time.
The conveyor buttons are located on two sides of the
power box/hub on the driver's side of the hopper.
1. Disconnect the chute and remove it entirely.
Position the material receptacle or walk-behind
spreader under the end of the conveyor.
2. Standing to one side of the conveyor exit, press
and hold both buttons to operate the conveyor.
3. To stop the conveyor, release one or both buttons.
Lit. No. 99761/99762, Rev. 02
OPERATING THE SPREADER
Conveyor Buttons
19
ACCESSORY WORK LIGHT
Electric-powered spreaders are equipped with a
button to operate an accessory work light. The button
is on the rear of the power box on the driver's side of
the hopper. The work light can also be turned on and
off from the cab control.
The accessory rear lighting package includes a
harness, relay, fuse, and LED work light. A second
LED light and harness can be added as well.
Accessory work light kits are available through your
authorized dealer.
Accessory Work
Light Button
CONVEYOR
ACCESSORY
WORK LIGHT
Press
both
buttons
to operate.
See
Owner's
Manual
for
complete
instructions.
January 1, 2017