Operating The Spreader - Cab Control; Starting And Stopping Spreader - Western Tornado 78000-1 Owner's Manual

OPERATING THE SPREADER – CAB CONTROL
WARNING
Never operate equipment when under the
influence of alcohol, drugs, or medications that
might alter your judgment and/or reaction time.
WARNING
Never exceed 45 mph (72 km/h) when loaded
spreader is attached to vehicle. Braking
distances may be increased and handling
characteristics may be impaired at speeds
above 45 mph (72 km/h).
WARNING
Never allow children to operate or climb on
equipment.
Material Width
Control Knob
(Spinner Speed)
Indicator Lights
(8 per Knob)
Lit. No. 99761/99762, Rev. 02
Accessory
Control Buttons
VIBRATE LIGHT
Material
Width
ON/OFF
MIN MAX
ON/OFF Button
& Emergency Stop

STARTING AND STOPPING SPREADER

Before starting the spreader, the driver shall
verify that all bystanders are a minimum of
25 feet away from operating spreader.
To start the spreader, press the ON/OFF button. The
control backlights are illuminated when the vehicle
ignition is ON. When the spreader is ON, the ON/OFF
button and inner arc around each control knob will
also illuminate.
To stop the spreader, press the ON/OFF button
again.
The ON/OFF button also operates as an emergency
stop when required.
NOTE: The truck ignition must be ON to start
the spreader.
NOTE: If truck ignition is turned OFF while
spreader is running, the motors will stop.
STROBE PREWET
BLAST
MIN
BLAST Button
(Maximum Application)
14
WARNING
Status/Error Code
Display (Red)
Material Flow
Material
Control Knob
Flow
(Feed Rate)
MAX
January 1, 2017